Top

Networking Basics

31.

Which WLAN IEEE specification allows up to 54Mbps at 2.4GHz?

Answer: C

IEEE 802.11B is 2.4GHz, but with a maximum of only 11Mbps. IEEE 802.11G is in the 2.4GHz range, with a top speed of 54Mbps.

Enter details here

32.

A list of protocols used by a system, one protocol per layer, is called:

Answer: B

None.

Enter details here

33.

What PPP protocol provides dynamic addressing, authentication, and multilink?

Answer: C

Link Control Protocol in the PPP stack provides dynamic addressing, authentication, and multilink.

Enter details here

34.

\Which command is used to upgrade an IOS on a Cisco router?

Answer: D

The copy tftp flash command places a new file in flash memory, which is the default location for the Cisco IOS in Cisco routers.

Enter details here

35.

A _______ is the physical path over which a message travels.

Answer: B

Explanation: Messages travel from sender to receiver via a physical path called the medium using a set of methods/rules called protocol. Mediums can be guided (wired) or unguided (wireless).

Enter details here

36.

Which protocol is used to send a destination network unknown message back to originating hosts?

Answer: C

ICMP is the protocol at the Network layer that is used to send messages back to an originating router.

Enter details here

37.

What protocols are used to configure trunking on a switch?

1.VLAN Trunking Protocol

2.VLAN

3.802.1Q

4.ISL

Answer: A

VTP is not right because it has nothing to do with trunking except that it sends VLAN information across a trunk link. 802.1Q and ISL are used to configure trunking on a port.

Enter details here

38.

What flavor of Network Address Translation can be used to have one IP address allow many users to connect to the global Internet?

Answer: D

Port Address Translation (PAT) allows a one-to-many approach to network address translation.

Enter details here

39.

Which one of the following computer network is built on the top of another network?

Answer: D

None.

Enter details here

40.

You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does each host have to the server?

Answer: D

Each device has 10 Mbps to the server.

Enter details here

Loading…
Tags: Networking Basics Questions and Answers || Networking Basics MCQ Questions and Answers || Networking Basics GK Questions and Answers || Networking Basics GK MCQ Questions || Networking Basics Multiple Choice Questions and Answers || Networking Basics GK || GK on Networking Basics || Computer Networking Questions and Answers || Computer Networking MCQ Questions and Answers || Computer Networking GK Questions and Answers || GK on Computer Networking